I bought some aftermarket dust boots and bump stops, I think KYB that turned out to fit like crap. My original boots are actually in decent condition so I'm reusing them but the bump stops are junk, they're torn towards the bottom
I only have about 1.75 inches left of the original bump stop but my new ones are 3 inches. Pretty certain that's not right and since I just put on Tanabe lowering springs I don't wanna have the ride screwed up because the bump stops are too long.
Any suggestions on length here? I can cut them however long is necessary. Thanks
OEM Front Bump Stop Length? Or go shorter? - nissubaru15:34:08 07/14/17