TwinTurbo.NET: Nissan 300ZX forum - Yes (n/m)
Subject
Yes (n/m)
Posted by
Khronik
on July 14, 2017 at 10:20 AM
This message has been viewed
495
times.
In Reply To
How was the gap measured? 4mm hex wrench? (n/m)
posted by jzack
on July 14, 2017 at 06:38 AM
Message
Follow Ups
Timing Belt Tensioner Gap Too Small
-
Khronik
21:22:20 07/12/17
Just to be clear, the smaller gap happens after the belt
-
jzack
22:13:29 07/12/17
Also - from where did you source the new tensioner? Who
-
jzack
22:25:05 07/12/17
OEM from CZP
-
Khronik
22:56:38 07/12/17
Re: Timing Belt Tensioner Gap Too Small
-
ooofoo
09:37:52 07/13/17
Wrong words... the old tensioner did not collapse
-
Khronik
18:14:57 07/13/17
A bad tensioner part is the only thing that makes sense (n/m)
-
jzack
23:06:00 07/13/17
How was the gap measured? 4mm hex wrench? (n/m)
-
jzack
06:38:33 07/14/17
Yes (n/m) -
Khronik
10:20:23 07/14/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.