Subject	How was the gap measured? 4mm hex wrench? (n/m)
Posted by	jzack on July 14, 2017 at 6:38 AM
	This message has been viewed 473 times.
In Reply To	A bad tensioner part is the only thing that makes sense (n/m) posted by jzack on July 13, 2017 at 11:06 PM
Message
Follow Ups	Timing Belt Tensioner Gap Too Small - Khronik 21:22:20 07/12/17 Just to be clear, the smaller gap happens after the belt - jzack 22:13:29 07/12/17 Also - from where did you source the new tensioner? Who - jzack 22:25:05 07/12/17 OEM from CZP - Khronik 22:56:38 07/12/17 Re: Timing Belt Tensioner Gap Too Small - ooofoo 09:37:52 07/13/17 Wrong words... the old tensioner did not collapse - Khronik 18:14:57 07/13/17 A bad tensioner part is the only thing that makes sense (n/m) - jzack 23:06:00 07/13/17 How was the gap measured? 4mm hex wrench? (n/m) - jzack 06:38:33 07/14/17 Yes (n/m) - Khronik 10:20:23 07/14/17
Post a Followup	You cannot reply to this message because you are not logged in.