Subject	Nope. I thought of that too.
Posted by	OverZealous (CT) on July 02, 2017 at 11:39 PM
	This message has been viewed 466 times.
In Reply To	If engine bay looks aren't important maybe they can be zip posted by jzack on July 02, 2017 at 10:00 PM
Message	I appreciate the workaround, however, zip ties will slip off because the tower is tapered slightly. A thin wire is a more robust idea but still requires something to offset the smooth tower taper. Either way, I fixed the problem of the elbow coming out already with the long bolt from the timing belt cover. The new problem is the blow-by gases are getting out through the gap left by a loose fitting elbow being held in place by the bolt. Seems I can't win. Any other ideas? OverZealous (CT) My General posts (click)
Follow Ups	Valve Cover PCV Elbow Oil Mist Problem - OverZealous (CT) 20:22:06 07/02/17 JB Weld it. (n/m) - MixManMash 20:29:37 07/02/17 Doesn't work. - OverZealous (CT) 21:02:15 07/02/17 If engine bay looks aren't important maybe they can be zip - jzack 22:00:48 07/02/17 Nope. I thought of that too. - OverZealous (CT) 23:39:18 07/02/17 You might have better luck with a flexible sealant>> - ZUL8TR 04:33:21 07/03/17 PS: I pay about $4.00 per 3.7 oz tube at local stores. - ZUL8TR 04:41:05 07/03/17 I'll look into this. - OverZealous (CT) 10:47:01 07/03/17 E6000 just clean surfaces to glue with lacquer thinner (n/m) - ZUL8TR 01:25:48 07/04/17 You're right about the crazy Amazon prices! Thanks. (n/m) - OverZealous (CT) 21:18:13 07/04/17 Xcuse, l I didn't know what Lbow you were referring to. (n/m) - ZUL8TR 04:46:05 07/05/17
Post a Followup	You cannot reply to this message because you are not logged in.