What fuel? posted by MixManMash on June 29, 2017 at 09:10 AM
Message
Yet so no e85 right now. I can see how the inlet diameters would create some restriction to flow but remember that the most restrictive orifice in the inlet track is at the turbine wheel which is smaller than stock piping... Do you have any info that shows before and after spool times?
I have ran with boost controller in open and closed loop mode and verified it doesn't start controlling until my set point. My wastegate actuators are set to around 18 psi and have verified with air compressor.
About how off do my numbers seem? About what rpm would you expect 10 psi?