Subject	Check your O2s. You may even want to try unplugging them to
Posted by	MixManMash on May 27, 2017 at 8:41 AM
	This message has been viewed 416 times.
In Reply To	Idle screw is not all the way in, that's why I'm so confused posted by itsa300zx on May 27, 2017 at 12:30 AM
Message	see if that prevents the idle from bouncing around. Check for corrosion in the harness connectors / wires in the EFI harness. In my old harness, the insulation was degrading and the wires were corroded about 16-24" up from the connector. I had to replace that section of wire before my problem went away.
Follow Ups	wideband at idle goes from 13 to 15-16 then back to 13 - Smokiedabear 13:10:36 05/23/17 Re: wideband at idle goes from 13 to 15-16 then back to 13 - Cjw3 16:42:56 05/23/17 Idle is in Open Loop ...... - zx299 01:19:53 05/24/17 That has been proven wrong. - Cjw3 06:49:14 05/24/17 Ah. Finaly someone came to their senses... - kickerzx 08:34:55 05/24/17 All I have is forum Conversations - Cjw3 09:43:11 05/24/17 Exelent. I always knew it was CL as nothing else really - kickerzx 14:33:20 05/24/17 Here is the Link.. - Cjw3 20:51:23 05/24/17 Check that the PCV hardlines coming out of the intake valve - MixManMash 17:50:39 05/23/17 Re: Check that the PCV hardlines coming out of the intake valve - Cjw3 18:06:43 05/23/17 One other thing to check is the O2 sensors and - MixManMash 07:06:24 05/24/17 Here: - MixManMash 07:09:02 05/24/17 02 sensors makes sense - Smokiedabear 16:59:28 05/24/17 resetting throttle position switch looks to have fixed! thx! (n/m) - Smokiedabear 09:14:42 05/25/17 i have a question for tps reset... - itsa300zx 20:08:03 05/25/17 Nope. It can be running. When you unplug it, the RPM will - MixManMash 21:34:41 05/25/17 Re: Nope. It can be running. When you unplug it, the RPM will - itsa300zx 22:20:34 05/25/17 Sounds like something else going on if it just shuts off. - MixManMash 23:03:59 05/25/17 Thanks, I'll take a closer look at the IACV. (n/m) - itsa300zx 08:35:14 05/26/17 Is the adjustment screw all the way in? Even if the IACV - MixManMash 19:19:01 05/26/17 Idle screw is not all the way in, that's why I'm so confused - itsa300zx 00:30:24 05/27/17 Something really goofy is going on there. - MixManMash 08:38:57 05/27/17 Check your O2s. You may even want to try unplugging them to - MixManMash 08:41:59 05/27/17 Re: Check your O2s. You may even want to try unplugging them to - itsa300zx 15:29:13 05/27/17 Also tried another ecu with same EPROM, still dies when - itsa300zx 20:00:24 05/27/17 If the throttle bodies are dirty, that could be part of - MixManMash 08:36:20 05/28/17 Are you still running PCV valves? - FrozTTy 12:22:23 05/29/17 Re: Are you still running PCV valves? - itsa300zx 14:51:51 05/29/17
Post a Followup	You cannot reply to this message because you are not logged in.