Subject	Did you do a complete pre assembled new strut, tower>>
Posted by	ZUL8TR on May 08, 2017 at 5:23 AM
	This message has been viewed 381 times.
In Reply To	Shock washer rubbing posted by OldSchoolTT on May 06, 2017 at 06:22 PM
Message	and shock or did you take yours apart and install a shock and reassemble? If the latter approach was used was the spring and top plate properly aligned and the correct end of the spring at the top plate? With the 2 bolt secure holes at the top there is no other way to install incorrectly. ZUL8TR
Follow Ups	Shock washer rubbing - OldSchoolTT 18:22:38 05/06/17 Since nobody posted on your first duplicate post go>> - ZUL8TR 05:11:35 05/07/17 Re: Since nobody posted on your first duplicate post go>> - OldSchoolTT 08:09:10 05/07/17 where was the alignment of the washer before you >> - ZUL8TR 09:18:00 05/07/17 Re: where was the alignment of the washer before you >> - OldSchoolTT 18:23:39 05/07/17 Did you do a complete pre assembled new strut, tower>> - ZUL8TR 05:23:07 05/08/17 Re: Did you do a complete pre assembled new strut, tower>> - OldSchoolTT 06:49:29 05/08/17 The oem had these on it - OldSchoolTT 06:57:35 05/08/17 If you assembled like OEM can't determine what is wrong>> - ZUL8TR 09:03:55 05/08/17 The oem had these on it - OldSchoolTT 07:46:18 05/08/17 Re: The oem had these on it - nissubaru 13:38:53 05/10/17 Re: Shock washer rubbing - nissubaru 13:19:06 05/10/17 Re: Re: Shock washer rubbing - nissubaru 13:42:26 05/10/17 Did you put these back on? - OldSchoolTT 13:48:52 05/11/17 Re: Did you put these back on? - nissubaru 20:37:01 05/12/17 Re: Re: Did you put these back on? - OldSchoolTT 00:22:57 05/13/17
Post a Followup	You cannot reply to this message because you are not logged in.