the ecu? I dont understand your statement "and i had each connected to one wire of the solenoid" The DP1 output provides ground to one of the wires on the solenoid. What is the other wire hooked up to? The other wire needs a switched 12v to it. Now looking at the wiring for the Haltech there are 13.8v outputs on the connector. According to the info this can provide 500mA max. Just ohmed a solenoid from the same controller and it ohmes 34.6ohm. That puts the draw just under 400mA. Althoug this seems OK with Haltechs limit i would personaly hook the solenoid feed to something else. However im not sure thats how you actually hooked it up tho. Same with the ethanolsensor. Needs 5v, sensor ground and signal. Where exactly did you hook them up?
|