TwinTurbo.NET: Nissan 300ZX forum - Trouble installing whiteline subframe bushings
People Seeking Info
 
   


     
Subject Trouble installing whiteline subframe bushings
     
Posted by Haasz32 on March 08, 2017 at 6:07 PM
  This message has been viewed 73 times.
     
     
Message I have the upper and lower short sleeves out and both full length sleeves out of the subframe bushing mounting holes. I pulled my whiteline bushings w92446 out of the freezer and began pressing them into subframe with a large vice. I get about .5 inches away from seating them and the torque required to move it farther is so great that my vice handle bends so I have to stop torqueing. Has anyone else had this problem? I'm thinking about buying a press pull sleeve kit to finish the job. However I don't know if the bolt and nut combo in a standard kit can handle the load. Anyone have any experience with those?

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.