TwinTurbo.NET: Nissan 300ZX forum - Could possibly be, but it seems more towards the front
Subject
Could possibly be, but it seems more towards the front
Posted by
Stanky
on March 01, 2017 at 12:36 PM
This message has been viewed
218
times.
In Reply To
Lightweight flywheel and clutch - gear rattle?
posted by Doug71zt(CAN)
on March 01, 2017 at 04:19 AM
Message
Where it meets the engine. It's also in neutral so not technically in any speed gear, but I'll run it through the gears today on the jack stands to see if i can isolate it a bit more.
Follow Ups
Engine noise.. video inside
-
Stanky
16:26:54 02/27/17
Does it change or go away when you push the clutch in? (n/m)
-
Tanley (ATL)
08:20:53 02/28/17
Yes it does! I'm guessing input bearing or pressure plate
-
Stanky
20:18:51 02/28/17
or clutch disc springs, either way tranny is coming out
-
Stanky
21:24:35 02/28/17
I just replaced all of that recently, new clutch, TOB...
-
Tanley (ATL)
21:49:17 02/28/17
Interesting.. mine only has 75,000 miles (120,000km)
-
Stanky
22:10:50 02/28/17
Lightweight flywheel and clutch - gear rattle?
-
Doug71zt(CAN)
04:19:01 03/01/17
Could possibly be, but it seems more towards the front -
Stanky
12:36:08 03/01/17
If you have a stethoscope, use that to see if you can
-
Tanley (ATL)
13:34:23 03/01/17
This. (n/m)
-
MixManMash
09:34:42 03/03/17
Does the sound go away when you are in 4th gear? (n/m)
-
SammybTT(TN)
11:44:45 03/02/17
God dammit........new video inside.
-
Stanky
23:58:07 03/02/17
You're talking about the ticking sound? (n/m)
-
OverZealous (CT)
21:02:16 03/04/17
No the "rattle" like sound. I think it's the intake cam gear
-
Stanky
12:55:02 03/05/17
I finally heard the rattle
-
OverZealous (CT)
19:11:23 03/06/17
Interesting, what's going on with the oil pressure? Hard to
-
Tanley (ATL)
07:06:16 03/07/17
Oil pressure is good. Cold start and once ito warned up.
-
Stanky
14:21:42 03/07/17
^ *once it's warmed up*.. stupid phone (n/m)
-
Stanky
14:22:37 03/07/17
What's your oil pressure at idle after it's warmed up? (n/m)
-
Tanley (ATL)
11:03:43 03/08/17
I use the factory gauge, it sits at the first line when warm
-
Stanky
22:09:13 03/08/17
I'd say that's probably a fair assumption, you only
-
Tanley (ATL)
08:28:19 03/09/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.