Subject	Re: Shouldn't your machine shop be doing this for you?
Posted by	Kvert on February 14, 2017 at 5:57 PM
	This message has been viewed 194 times.
In Reply To	Shouldn't your machine shop be doing this for you? posted by ZaXxon on February 14, 2017 at 02:29 PM
Message	They did the rod bolts and checked the big end. The feedback on the small end was the pins were "tight as a tick". Like i said in my original post, fitment seemed way to tight and I followed up with z1 to confirm my gut feeling. I then fixed the problem myself. All is well now and I can move on.
Follow Ups	Wiseco wrist pins fitment on stock rods - Kvert 14:56:50 02/12/17 Per the manual the pin to bushing clearance needs to be - ZaXxon 06:29:35 02/13/17 Follow up - Kvert 15:10:37 02/13/17 Shouldn't your machine shop be doing this for you? - ZaXxon 14:29:53 02/14/17 Re: Shouldn't your machine shop be doing this for you? - Kvert 17:57:54 02/14/17
Post a Followup	You cannot reply to this message because you are not logged in.