TwinTurbo.NET: Nissan 300ZX forum - Shouldn't your machine shop be doing this for you?
Subject
Shouldn't your machine shop be doing this for you?
Posted by
ZaXxon
on February 14, 2017 at 2:29 PM
This message has been viewed
204
times.
In Reply To
Follow up
posted by Kvert
on February 13, 2017 at 03:10 PM
Message
I had ARP bolts pressed into my stock rods and large ends re-sized, and the small ends honed all for $120. This doesn't include the cost of the ARP bolts.
Why are you not having this done?
Follow Ups
Wiseco wrist pins fitment on stock rods
-
Kvert
14:56:50 02/12/17
Per the manual the pin to bushing clearance needs to be
-
ZaXxon
06:29:35 02/13/17
Follow up
-
Kvert
15:10:37 02/13/17
Shouldn't your machine shop be doing this for you? -
ZaXxon
14:29:53 02/14/17
Re: Shouldn't your machine shop be doing this for you?
-
Kvert
17:57:54 02/14/17
Post a
Followup
You cannot reply to this message because you are not
logged in
.