Subject	Engine lifting bolt sizes
Posted by	ZxNut on February 12, 2017 at 8:30 PM
	This message has been viewed 263 times.
Message	I plan to use a engine load leveler to attach my engine to the crane to hoist it out, attaching two bolts one on either side of the plenum, as shown in this picture. [ http://www.egrapevine.info/article-image/123 ] does anybody know what size / thread these bolts would be? Thanks for the help. Dan
Follow Ups	Engine lifting bolt sizes - ZxNut 20:30:36 02/12/17 iirc, those side plenum bracket bolts were m8x1.25mm (n/m) - itsa300zx 21:43:53 02/12/17
Post a Followup	You cannot reply to this message because you are not logged in.