Subject	Re: correction
Posted by	Smokiedabear on November 17, 2016 at 10:06 AM
	This message has been viewed 245 times.
In Reply To	correction posted by BarryGZX on November 16, 2016 at 03:39 PM
Message	Put in another maf at initial startup did Rev past 3000 was pretty. Excited. Then shut off car restarted no Rev past 2400. Multimeter shows both middle grounds are good. Power wire has 12.66 off, 14.66 on. Signal wire has .27-.28 volts on or off doesn't change. Bad ecu? Was working before swap.
Follow Ups	Code 12? Tried 2 Mafs and different TPS - Smokiedabear 14:27:03 11/16/16 Re: Code 12? Tried 2 Mafs and different TPS - BarryGZX 15:15:21 11/16/16 Re: Re: Code 12? Tried 2 Mafs and different TPS - Smokiedabear 15:18:54 11/16/16 Re: Re: Re: Code 12? Tried 2 Mafs and different TPS - BarryGZX 15:36:07 11/16/16 correction - BarryGZX 15:39:24 11/16/16 Re: correction - Smokiedabear 15:58:59 11/16/16 Re: Re: correction - pimpin300zxTT 19:44:13 11/19/16 Re: correction - Smokiedabear 10:06:08 11/17/16 Re: Re: correction - BarryGZX 14:28:18 11/17/16 Re: Re: Re: correction - Smokiedabear 15:34:08 11/17/16 Re: correction - Smokiedabear 10:31:34 11/17/16 Per my post below, I am more than willing to bet the harness - MixManMash 18:00:19 11/17/16 Re: Per my post below, I am more than willing to bet the harness - Smokiedabear 18:41:16 11/17/16 Re: Per my post below, I am more than willing to bet the harness - Smokiedabear 18:43:20 11/17/16 Re: Per my post below, I am more than willing to bet the harness - Smokiedabear 19:40:09 11/17/16 Re: Per my post below, I am more than willing to bet the harness - Smokiedabear 21:03:51 11/17/16 Re: Code 12? Tried 2 Mafs and different TPS - BarryGZX 15:49:06 11/16/16 I have seen it where the connector on the harness is not - MixManMash 17:58:35 11/17/16 Re: I have seen it where the connector on the harness is not - Smokiedabear 19:14:25 11/21/16 Re: I have seen it where the connector on the harness is not - Smokiedabear 19:49:39 11/21/16 Re: Re: I have seen it where the connector on the harness is not - Smokiedabear 10:12:51 11/26/16 Re: Re: I have seen it where the connector on the harness is not - Smokiedabear 12:51:17 11/26/16
Post a Followup	You cannot reply to this message because you are not logged in.