TwinTurbo.NET: Nissan 300ZX forum - Just grind it. Use a caliper to measure the thickness and
People Seeking Info
 
   


     
Subject Just grind it. Use a caliper to measure the thickness and
     
Posted by upcominZ_(NOLA) on November 08, 2016 at 12:02 AM
  This message has been viewed 358 times.
     
In Reply To TT / NA Transmission Bellhousing swap (potential issues) posted by 604Zed on November 07, 2016 at 03:54 PM
     
Message A ruler as a strait edge to keep it uniform. A grinding disk then a flapper sanding disk on a 7" grinder will make it a 5min job. Take off 3/16th. Doesnt have to be nasa exact.

===================================Sig==============================
'You know how an SUV sits just high enough to a Z that their damn headlights blind the shit out of you? Well on an H2 it’s almost like the movies when the person is being abducted by aliens.' james-lee

"I'd rather stroke it. (n/m) - Ash's Z 22:45:31 10/30/06"

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.