TwinTurbo.NET: Nissan 300ZX forum - You will NOT be able to adjust pressure with it at full tilt
Subject
You will NOT be able to adjust pressure with it at full tilt
Posted by
kickerzx
on November 07, 2016 at 3:17 PM
This message has been viewed
360
times.
In Reply To
Re: Walbro 485 pump install question
posted by Captconan
on November 07, 2016 at 02:31 PM
Message
Not even with an aftermarket regulator if you still run with the stock returnlines.
Get an upgraded fpcu or hook up an ssr and pwm it that way. If your haltech can handle that task that is...
Follow Ups
Walbro 485 pump install question
-
Stanky
12:54:00 11/07/16
I just bypassed the FPCU and have been running it like that
-
MixManMash
12:59:48 11/07/16
Good to hear. Running a stock fpr?
-
Stanky
14:24:44 11/07/16
Yes. That's what Greg@SZ told me to run. (n/m)
-
MixManMash
17:11:37 11/07/16
Re: Walbro 485 pump install question
-
Captconan
14:31:53 11/07/16
You will NOT be able to adjust pressure with it at full tilt -
kickerzx
15:17:44 11/07/16
2nd I just replaced the stock pump and keep FPCU and wiring
-
SammybTT(TN)
15:09:47 11/09/16
Re: 2nd I just replaced the stock pump and keep FPCU and wiring
-
Captconan
12:50:50 11/10/16
Thicker wire...relay, bypass FPCU and all done
-
Madhatter10-6
16:34:31 11/07/16
Post a
Followup
You cannot reply to this message because you are not
logged in
.