Subject	I have not separated a bell housing personally, but
Posted by	itsa300zx on November 07, 2016 at 5:38 PM
	This message has been viewed 307 times.
In Reply To	Re: I would think you need to remove the "bell housing" posted by 604Zed on November 07, 2016 at 05:25 PM
Message	a local said that no press or puller was needed. If you are able to get the starter mount machined at such a low cost, go for it. You have the NA trans as a template
Follow Ups	TT / NA Transmission Bellhousing swap (potential issues) - 604Zed 15:54:32 11/07/16 Honestly, I would save the hassle and buy a TT flywheel set (n/m) - -Grimm- 15:59:58 11/07/16 Re: Honestly, I would save the hassle and buy a TT flywheel set - 604Zed 16:20:44 11/07/16 Re: Re: Honestly, I would save the hassle and buy a TT flywheel set - itsa300zx 16:31:17 11/07/16 Re: Re: Re: Honestly, I would save the hassle and buy a TT flywheel set - 604Zed 16:41:25 11/07/16 I would think you need to remove the "bell housing" - itsa300zx 16:49:38 11/07/16 Re: I would think you need to remove the "bell housing" - 604Zed 17:25:19 11/07/16 I have not separated a bell housing personally, but - itsa300zx 17:38:57 11/07/16 Re: I have not separated a bell housing personally, but - 604Zed 21:00:59 11/07/16 Re: Re: I have not separated a bell housing personally, but - 604Zed 23:15:10 11/08/16 Re: I have not separated a bell housing personally, but - 604Zed 21:54:17 11/07/16 Re: TT / NA Transmission Bellhousing swap (potential issues) - 604Zed 16:29:50 11/07/16 Just grind it. Use a caliper to measure the thickness and - upcominZ_(NOLA) 00:02:23 11/08/16 Re: Just grind it. Use a caliper to measure the thickness and - 604Zed 02:56:05 11/10/16 I haven't done it, but it cant be too difficult. You do it - upcominZ_(NOLA) 23:56:22 11/15/16 Re: I haven't done it, but it cant be too difficult. You do it - 604Zed 23:24:22 11/16/16
Post a Followup	You cannot reply to this message because you are not logged in.