Subject	Re: Re: Re: Honestly, I would save the hassle and buy a TT flywheel set
Posted by	604Zed on November 07, 2016 at 4:41 PM
	This message has been viewed 363 times.
In Reply To	Re: Re: Honestly, I would save the hassle and buy a TT flywheel set posted by itsa300zx on November 07, 2016 at 04:31 PM
Message	Thank-you kindly for this link. i sent it to my mechanic on what to expect. So there are no bearings impressed into the sides of the front portions of the bell housing then? What are your thoughts of just getting the starter mount milled? thanks,
Follow Ups	TT / NA Transmission Bellhousing swap (potential issues) - 604Zed 15:54:32 11/07/16 Honestly, I would save the hassle and buy a TT flywheel set (n/m) - -Grimm- 15:59:58 11/07/16 Re: Honestly, I would save the hassle and buy a TT flywheel set - 604Zed 16:20:44 11/07/16 Re: Re: Honestly, I would save the hassle and buy a TT flywheel set - itsa300zx 16:31:17 11/07/16 Re: Re: Re: Honestly, I would save the hassle and buy a TT flywheel set - 604Zed 16:41:25 11/07/16 I would think you need to remove the "bell housing" - itsa300zx 16:49:38 11/07/16 Re: I would think you need to remove the "bell housing" - 604Zed 17:25:19 11/07/16 I have not separated a bell housing personally, but - itsa300zx 17:38:57 11/07/16 Re: I have not separated a bell housing personally, but - 604Zed 21:00:59 11/07/16 Re: Re: I have not separated a bell housing personally, but - 604Zed 23:15:10 11/08/16 Re: I have not separated a bell housing personally, but - 604Zed 21:54:17 11/07/16 Re: TT / NA Transmission Bellhousing swap (potential issues) - 604Zed 16:29:50 11/07/16 Just grind it. Use a caliper to measure the thickness and - upcominZ_(NOLA) 00:02:23 11/08/16 Re: Just grind it. Use a caliper to measure the thickness and - 604Zed 02:56:05 11/10/16 I haven't done it, but it cant be too difficult. You do it - upcominZ_(NOLA) 23:56:22 11/15/16 Re: I haven't done it, but it cant be too difficult. You do it - 604Zed 23:24:22 11/16/16
Post a Followup	You cannot reply to this message because you are not logged in.