Subject	Re: Honestly, I would save the hassle and buy a TT flywheel set
Posted by	604Zed on November 07, 2016 at 4:20 PM
	This message has been viewed 354 times.
In Reply To	Honestly, I would save the hassle and buy a TT flywheel set (n/m) posted by -Grimm- on November 07, 2016 at 03:59 PM
Message	AGerred changing the bell housings could be a real potential hassle. Also selling my NA clutch and flywheel and paying $$$ for the TT flywheel and clutch is also a hassle. I think getting the starter mount (outside of bell) milled by however much, (I heard 1/8" but also comparing the two would help), might be the answer, but I wanted to see if anyone had success with this, or not.
Follow Ups	TT / NA Transmission Bellhousing swap (potential issues) - 604Zed 15:54:32 11/07/16 Honestly, I would save the hassle and buy a TT flywheel set (n/m) - -Grimm- 15:59:58 11/07/16 Re: Honestly, I would save the hassle and buy a TT flywheel set - 604Zed 16:20:44 11/07/16 Re: Re: Honestly, I would save the hassle and buy a TT flywheel set - itsa300zx 16:31:17 11/07/16 Re: Re: Re: Honestly, I would save the hassle and buy a TT flywheel set - 604Zed 16:41:25 11/07/16 I would think you need to remove the "bell housing" - itsa300zx 16:49:38 11/07/16 Re: I would think you need to remove the "bell housing" - 604Zed 17:25:19 11/07/16 I have not separated a bell housing personally, but - itsa300zx 17:38:57 11/07/16 Re: I have not separated a bell housing personally, but - 604Zed 21:00:59 11/07/16 Re: Re: I have not separated a bell housing personally, but - 604Zed 23:15:10 11/08/16 Re: I have not separated a bell housing personally, but - 604Zed 21:54:17 11/07/16 Re: TT / NA Transmission Bellhousing swap (potential issues) - 604Zed 16:29:50 11/07/16 Just grind it. Use a caliper to measure the thickness and - upcominZ_(NOLA) 00:02:23 11/08/16 Re: Just grind it. Use a caliper to measure the thickness and - 604Zed 02:56:05 11/10/16 I haven't done it, but it cant be too difficult. You do it - upcominZ_(NOLA) 23:56:22 11/15/16 Re: I haven't done it, but it cant be too difficult. You do it - 604Zed 23:24:22 11/16/16
Post a Followup	You cannot reply to this message because you are not logged in.