Subject	It's not supposed to be black - they are stainless.
Posted by	Bernie (NoVA) on October 29, 2016 at 8:11 PM
	This message has been viewed 236 times.
In Reply To	Realized as much after looking through the documention... posted by mysticLegoZ on October 29, 2016 at 07:49 PM
Message	A trip to a hardware store w. an example from the other side would be by far the simplest option. You're over thinking it. Bernie Bilski berniebilski@cox.net President of Z-Car Club of Northern Virginia 1995 Nissan 300ZX TwinTurbo in Cobalt Green 1997 Nissan 240SX SE in Ultra Red 2006 Nissan Frontier SE in Ultra Black
Follow Ups	Turn signal housing removal (with stripped bottom screw)? - mysticLegoZ 10:51:09 10/29/16 Re: Turn signal housing removal (with stripped bottom screw)? - itsa300zx 11:23:23 10/29/16 Same (n/m) - -Grimm- 15:02:29 10/29/16 Thanks, prying while unscrewing worked... - mysticLegoZ 16:34:12 10/29/16 Follow up Q: Are the dimensions of the screws readily known? - mysticLegoZ 16:41:10 10/29/16 Same as the passengers side.. (n/m) - ttz'in (norcal) 17:11:51 10/29/16 Hardware dimensions are not in the manual. (n/m) - Bernie (NoVA) 17:28:36 10/29/16 Realized as much after looking through the documention... - mysticLegoZ 19:49:37 10/29/16 It's not supposed to be black - they are stainless. - Bernie (NoVA) 20:11:48 10/29/16 Per the hardware store, closest match was a #8 x 1-1/4 in... - mysticLegoZ 15:21:23 10/30/16 If it's the plastic that's damaged...I use plast-aid to fill - white22sky 18:08:53 10/29/16 Thanks, good to know. (n/m) - mysticLegoZ 19:50:55 10/29/16 *re-thread (n/m) - white22sky 19:57:40 10/29/16
Post a Followup	You cannot reply to this message because you are not logged in.