Subject	Re: Turn signal housing removal (with stripped bottom screw)?
Posted by	itsa300zx on October 29, 2016 at 11:23 AM
	This message has been viewed 248 times.
In Reply To	Turn signal housing removal (with stripped bottom screw)? posted by mysticLegoZ on October 29, 2016 at 10:51 AM
Message	I had a similar issue with the top screw. Use a plastic trim removal tool and pry gently outward while uncrewing. In my case that was just enough to get the screw to "grab" the threads further down.
Follow Ups	Turn signal housing removal (with stripped bottom screw)? - mysticLegoZ 10:51:09 10/29/16 Re: Turn signal housing removal (with stripped bottom screw)? - itsa300zx 11:23:23 10/29/16 Same (n/m) - -Grimm- 15:02:29 10/29/16 Thanks, prying while unscrewing worked... - mysticLegoZ 16:34:12 10/29/16 Follow up Q: Are the dimensions of the screws readily known? - mysticLegoZ 16:41:10 10/29/16 Same as the passengers side.. (n/m) - ttz'in (norcal) 17:11:51 10/29/16 Hardware dimensions are not in the manual. (n/m) - Bernie (NoVA) 17:28:36 10/29/16 Realized as much after looking through the documention... - mysticLegoZ 19:49:37 10/29/16 It's not supposed to be black - they are stainless. - Bernie (NoVA) 20:11:48 10/29/16 Per the hardware store, closest match was a #8 x 1-1/4 in... - mysticLegoZ 15:21:23 10/30/16 If it's the plastic that's damaged...I use plast-aid to fill - white22sky 18:08:53 10/29/16 Thanks, good to know. (n/m) - mysticLegoZ 19:50:55 10/29/16 *re-thread (n/m) - white22sky 19:57:40 10/29/16
Post a Followup	You cannot reply to this message because you are not logged in.