Subject	Turn signal housing removal (with stripped bottom screw)?
Posted by	mysticLegoZ on October 29, 2016 at 10:51 AM
	This message has been viewed 288 times.
Message	Q: Regarding the driver's side front turn signal housing: If the bottom screw is stripped (spinning without any forward/backward movement) and the top screw is fully removed, is there any recommended process for removing the housing? I am a bit wary of prying at the housing. Potential damage including the plastic/lens (which seems brittle), surrounding paint, and any unknown effects of pulling with the screw in place. The end goal is to replace the bulb. Any ideas/recommendations will be appreciated. Thanks
Follow Ups	Turn signal housing removal (with stripped bottom screw)? - mysticLegoZ 10:51:09 10/29/16 Re: Turn signal housing removal (with stripped bottom screw)? - itsa300zx 11:23:23 10/29/16 Same (n/m) - -Grimm- 15:02:29 10/29/16 Thanks, prying while unscrewing worked... - mysticLegoZ 16:34:12 10/29/16 Follow up Q: Are the dimensions of the screws readily known? - mysticLegoZ 16:41:10 10/29/16 Same as the passengers side.. (n/m) - ttz'in (norcal) 17:11:51 10/29/16 Hardware dimensions are not in the manual. (n/m) - Bernie (NoVA) 17:28:36 10/29/16 Realized as much after looking through the documention... - mysticLegoZ 19:49:37 10/29/16 It's not supposed to be black - they are stainless. - Bernie (NoVA) 20:11:48 10/29/16 Per the hardware store, closest match was a #8 x 1-1/4 in... - mysticLegoZ 15:21:23 10/30/16 If it's the plastic that's damaged...I use plast-aid to fill - white22sky 18:08:53 10/29/16 Thanks, good to know. (n/m) - mysticLegoZ 19:50:55 10/29/16 *re-thread (n/m) - white22sky 19:57:40 10/29/16
Post a Followup	You cannot reply to this message because you are not logged in.