Subject	I'd send it back, preferably for one that doesn't...
Posted by	Ted (92TT) on October 18, 2016 at 7:36 PM
	This message has been viewed 233 times.
In Reply To	I need a quick second opinion. posted by YlwPrlZTT on October 18, 2016 at 05:50 PM
Message	look like it's been sitting in a pond. Most likely, removing the output shaft is just a c-clip inside the carrier, but you probably need a new seal too and that rust doesn't give me the warm fuzzies. My experience with Z1 "good" used parts is the money saved is never worth the headache incurred and effort expended.
Follow Ups	I need a quick second opinion. - YlwPrlZTT 17:50:51 10/18/16 Also, how hard is it to replace the output shaft? I could - YlwPrlZTT 18:00:52 10/18/16 I'd send it back, preferably for one that doesn't... - Ted (92TT) 19:36:59 10/18/16 That was my issue too, I really didn't like the amount of - YlwPrlZTT 20:20:33 10/18/16 Pinion is removed by taking the nut off and sliding it out - white22sky 21:13:54 10/18/16 I would have them send you a shipping label for return... - -Grimm- 09:48:52 10/19/16 The box was fine, I thought that too, that maybe it was d - YlwPrlZTT 11:12:49 10/19/16 Are they going to send you... - -Grimm- 12:58:53 10/19/16 Just swap over a good output shaft. It's simple. (n/m) - Bernie (NoVA) 17:22:33 10/19/16 Well I looked closely and the other output shaft is also - YlwPrlZTT 06:49:37 10/20/16 There's a little more to doing the job right - DAYTONAZ 11:32:40 10/22/16
Post a Followup	You cannot reply to this message because you are not logged in.