Subject	With my Auto, I don't bother to tilt the engine.
Posted by	not4resaleZ on September 15, 2016 at 11:04 AM
	This message has been viewed 231 times.
In Reply To	Yep...just like doing a clutch job. It doesn't need to tilt posted by white22sky on September 14, 2016 at 08:24 PM
Message	No clutch in the way, just two little alignment pins, so you can raise and position the transmission about a half inch behind the engine and align the mating flanges, then slide it forward onto the pins. Top bolts are hard to reach, but I can get them.
Follow Ups	Getting ready to install transmission, is this easier? - MidnightZ 21:51:51 09/13/16 Trans installed on engine before dropping into chassis - dfenton2 22:05:07 09/13/16 I think you can get it in just by tilting the engine back - -Grimm- 10:47:05 09/14/16 Yep...just like doing a clutch job. It doesn't need to tilt - white22sky 20:24:33 09/14/16 With my Auto, I don't bother to tilt the engine. - not4resaleZ 11:04:36 09/15/16 Flex plate is kind of in the way, but you can still - not4resaleZ 12:42:32 09/15/16 I've just always done it that way. Makes getting the top - white22sky 16:34:02 09/15/16 Agreed - ThisIsSparTTa 10:59:10 09/15/16 Don't drop the engine - ZaXxon 06:20:53 09/15/16
Post a Followup	You cannot reply to this message because you are not logged in.