Subject	Does anybody know the pitch of these threads?
Posted by	ZxNut on September 13, 2016 at 2:13 PM
	This message has been viewed 194 times.
Message	https://postimg.org/image/8bvu6lv17 https://postimg.org/image/8bvu6lv17 Hi guys, so i was putting one of the water pipes back onto the rear of the head after getting it back from the machine shop, the right side threaded fine but the one on the left (circled in black) has stripped at the start of the thread and looks like a mess, It an m10 bolt but does anybody know the pitch size so i can order the appropriate heli-coil set.. i was unsure if it is m10 x 1.0 or m10 x 1.25 and didnt want to buy both..any help would be gladly apprechiated! thanks!
Follow Ups	Does anybody know the pitch of these threads? - ZxNut 14:13:37 09/13/16 Likely 1.25 - -Grimm- 15:15:41 09/13/16 Re: Does anybody know the pitch of these threads? - ZxNut 15:40:46 09/13/16 It a M6 with a 10mm head; all m6 bolts are 1.0mm pitch (n/m) - itsa300zx 15:57:06 09/13/16
Post a Followup	You cannot reply to this message because you are not logged in.