Subject	No power to starter signal wire...
Posted by	MaxxAction on September 10, 2016 at 12:17 AM
	This message has been viewed 352 times.
Message	So I swapped a motor from one car to another for a local guy, and after getting the car back together, no start. Long story short, the relay is good, the battery is good, the connections are all good, and the starter is good, but we have no power to the signal wire. I have read about this issue all over the place, but no one ever seems to post if the issue was ever resolved. Anyone ever seen this, and were you able to fix it?
Follow Ups	No power to starter signal wire... - MaxxAction 00:17:51 09/10/16 The connectors behind the passenger side headlight are all - jzack 08:27:19 09/10/16 Re: The connectors behind the passenger side headlight are all - MaxxAction 09:06:45 09/10/16 Unless you've already tried this...jumper the wheel well - jzack 12:36:22 09/10/16 BTW - when you do this connect a meter to the jumper and see - jzack 12:51:27 09/10/16 Re: BTW - when you do this connect a meter to the jumper and see - MaxxAction 15:43:33 09/10/16 Best not to overthink the issue, break the issue down into - jzack 22:37:14 09/10/16 Re: Best not to overthink the issue, break the issue down into - MaxxAction 06:27:57 09/12/16 Turning the key all the way sounds like maybe an ignition - jzack 11:34:18 09/12/16 The car doesnt/didnt have an aftermarket alarm by chance? (n/m) - -Grimm- 13:23:32 09/12/16 Re: The car doesnt/didnt have an aftermarket alarm by chance? - MaxxAction 13:42:43 09/12/16
Post a Followup	You cannot reply to this message because you are not logged in.