Subject	Nasty surface. Did someone try to scrape off a
Posted by	JMartz on September 08, 2016 at 9:29 AM
	This message has been viewed 233 times.
In Reply To	plenum not sealing correctly, gasket surface damaged? posted by surfer31337 on September 07, 2016 at 07:37 PM
Message	gasket? Could try sanding with 400 paper over a large flat surface or milling, Milling may aggravate port matching and will require removing lower plenum and blending the transitions.
Follow Ups	plenum not sealing correctly, gasket surface damaged? - surfer31337 19:37:14 09/07/16 I was getting kicked by a Plenum Leak.. - Cjw3 21:20:14 09/07/16 awesome!! can u make one for me? how much$$? (n/m) - surfer31337 21:59:46 09/07/16 That plenum looks fine and the bead of sealant - DAYTONAZ 06:56:57 09/10/16 Nasty surface. Did someone try to scrape off a - JMartz 09:29:43 09/08/16 Normally wouldn't suggest this due to issues down the road - jzack 17:20:05 09/08/16 I would do that and include the gasket and apply to >> - ZUL8TR 05:02:17 09/09/16
Post a Followup	You cannot reply to this message because you are not logged in.