Subject	New video
Posted by	platinumist on September 07, 2016 at 8:35 PM
	This message has been viewed 237 times.
In Reply To	Lean running issues posted by platinumist on September 06, 2016 at 08:02 PM
Message	Sorry about the awful quality, the frequency rate on my gauges make it almost impossible to read. But when I get to about 5 or 6psi the a/f numbers go way lean. The fuel pressure shows on the bottom of the boost gauge (almost impossible to see). I'm at maybe 48psi fuel at 6psi boost. The second video shows a couple of pulls at higher rpms with no issues and plenty of fuel pressure (50-60psi at ~16psi boost). Any more thoughts? I've heard the stock wiring is just barely under the amperage limit for the walbro 485, but that's when it is being pushed with really high flow. Mine seems to keep up fine at full pressure... First video of the lean conditions: https://youtu.be/ginmNsKglH4 Second video of a high rpm pull (the little rattle noise is my shift knob): https://youtu.be/eVOx8pgdHSk Third video of a cold start (a/f stays around 15 when FULLY warm): https://youtu.be/wZAvjts_yeE
Follow Ups	Lean running issues - platinumist 20:02:13 09/06/16 When did the issue start? Just out of the blue or after - jzack 21:42:20 09/06/16 Re: When did the issue start? Just out of the blue or after - platinumist 23:26:49 09/06/16 Re: Lean running issues - wh0sjeff 21:51:43 09/06/16 Re: Re: Lean running issues - platinumist 23:27:50 09/06/16 It doesnt say anything in your profile... - kickerzx 11:07:46 09/07/16 Looks like I didn't put the fpr in my profile, - platinumist 15:17:34 09/07/16 New video - platinumist 20:35:30 09/07/16 it could be the chip... - zromtech 14:08:27 09/09/16
Post a Followup	You cannot reply to this message because you are not logged in.