Subject	I did rings and bearings on one engine
Posted by	-Grimm- on August 24, 2016 at 12:03 PM
	This message has been viewed 235 times.
In Reply To	Just doing bearings? posted by BlackholeZ on August 24, 2016 at 11:34 AM
Message	Same reasoning as you, wanted to freshen up the engine Took advantage and cleaned/painted everything while it was out. Yes, you have to take the pan off to get your grades ------------------------------------------------------------------ 1992 300ZX NA 5 Sp (Dead) 1990 300ZX NA Auto 2+2 (Dead) 1990 300ZX TT 5 Sp (Stock Turbos) (Est. 400 HP) 1990 300ZX TT 5 Sp (GT600R) (Est. 600 HP) 2004 G35 Sport 6MT (DD) 2008 Honda Civic (DD) 2014 Nissan Murano (DD) 1969 Chevy C10 (Toy) 1969 Chevelle (Toy)
Follow Ups	Just doing bearings? - BlackholeZ 11:34:03 08/24/16 I did rings and bearings on one engine - -Grimm- 12:03:10 08/24/16 You pull the heads or pistons out the bottom? - BlackholeZ 12:22:25 08/24/16 Pulled the heads to hone (n/m) - -Grimm- 14:43:24 08/24/16 I've done 3 Z's from the bottom - Cjw3 17:53:24 08/24/16 What did the cranks look like when you did that? - BlackholeZ 14:02:47 08/25/16 All looked fine.. - Cjw3 20:28:35 08/25/16 I'd pull the engine and do it while it's on a stand, I can't - Tanley (ATL) 12:01:02 08/25/16 I haven't put a stethescope on it - BlackholeZ 14:12:15 08/25/16 Here's the link: - Tanley (ATL) 22:53:28 08/25/16 thanks! (n/m) - BlackholeZ 00:00:11 08/26/16
Post a Followup	You cannot reply to this message because you are not logged in.