Subject	Ah, you mean the daughter board.
Posted by	DVDBURN (MD) on August 03, 2016 at 3:05 PM
	This message has been viewed 314 times.
In Reply To	Actually, I miss read your post... posted by Barry (NJ) on August 03, 2016 at 07:19 AM
Message	Naw, that's OK. Those screws don't do anything but hold it in place. But do try what I said about the screws that hold the main board. If those aren't tight all kinds of things can go wrong. I've seen this in several ECUs I've repaired. www.mytwinturbo.com Nissan Data Voice - The first Nissan diagnostic software with a voice! Nissan Data Voice on YouTube Download my Nissan 300ZX Vin/Model Lookup.
Follow Ups	O2 sensor issues - Barry (NJ) 22:23:22 07/31/16 Did you reboot ECU after new O2 install? (n/m) - BarryGZX 01:46:45 08/01/16 Reboot the ECU(?) - Barry (NJ) 06:59:42 08/01/16 MAF or vacuum leak. MAF would be the first guess since both - jzack 08:58:09 08/01/16 Boost/Vacuum leak test is clean - Barry (NJ) 12:30:20 08/01/16 2 brand new sensors both being bad...doubtful. I'm - jzack 14:20:19 08/01/16 Low fuel pressure could cause whacky engine conditions - jzack 14:26:07 08/01/16 Checked fuel pressure, 40 psi at idle. (n/m) - Barry (NJ) 22:24:26 08/01/16 Just noticed I'm seeing 5+ volts from TPS - Barry (NJ) 18:58:15 08/01/16 TPS is a variable resistor acting as a simple - jzack 20:25:05 08/01/16 Disconnect your battery... - DVDBURN (MD) 21:16:31 08/01/16 Could the fact that there are only 2 - Barry (NJ) 06:19:43 08/02/16 Panel? The ECU bottom cover? (n/m) - DVDBURN (MD) 20:17:53 08/02/16 Actually, I miss read your post... - Barry (NJ) 07:19:22 08/03/16 Ah, you mean the daughter board. - DVDBURN (MD) 15:05:03 08/03/16 What's the reason? Screws provide grounding or is more - jzack 16:09:46 08/03/16 Yes, a ground issue. (n/m) - DVDBURN (MD) 12:23:40 08/06/16 Thought it might have been the SAFC - Barry (NJ) 06:18:15 08/02/16 Barry - did you figure this out? (n/m) - jzack 21:20:25 08/05/16
Post a Followup	You cannot reply to this message because you are not logged in.