Subject	-ES poly steering rack bushings
Posted by	Schmeal (NV) on July 01, 2016 at 12:04 PM
	This message has been viewed 309 times.
In Reply To	Getting ready to drop TT in posted by MidnightZ on July 01, 2016 at 10:26 AM
Message	The engine sitting on the mounts only will lean on the fire wall. I haven't had any issues with this. If you are concerned you can just leave the engine connected to the hoist to hold it up right until you install the trans. ------------------------------------------------- Work on your own car, and don't half ass it.
Follow Ups	Getting ready to drop TT in - MidnightZ 10:26:43 07/01/16 -ES poly steering rack bushings - Schmeal (NV) 12:04:07 07/01/16 Yes, ES poly steering rack bushings were done a while ago. (n/m) - MidnightZ 12:26:33 07/01/16 Upper clutch fluid bleed point delete? Have the rack - jzack 12:08:25 07/01/16 Engine pan and rear crank seal done as part of gasket kit. (n/m) - MidnightZ 12:27:39 07/01/16 Also swapped PS return hardline - MidnightZ 12:25:25 07/01/16 Without the trans - -Grimm- 14:36:14 07/01/16
Post a Followup	You cannot reply to this message because you are not logged in.