Subject	Getting ready to drop TT in
Posted by	MidnightZ on July 01, 2016 at 10:26 AM
	This message has been viewed 484 times.
Message	Hi guys, I think I'm ready to drop the TT in and I want to double check if I left anything out. I've done: TT gasket kit Upper plenum coolant bypass New hose everywhere like high pressure fuel hose, turbo oil return hoses, PCV, PS return hose...etc WS engine and detonate sensor harness SZ TT auto ECU socketing CC, AC, EGR delete TT intercooler & pipings Front Upper A-Arm spacers New engine mounts New steering rack HP hose copper washers PS pump, alternator, and starter harness mounted Also, is it ok if I install the transmission at a later time? What's the reasonable amount of time to leave the engine on the engine mounts without the third support from the transmission mount? BTW, here is my previous progress. TIA Paul's 1990 Midnight Blue 2+2
Follow Ups	Getting ready to drop TT in - MidnightZ 10:26:43 07/01/16 -ES poly steering rack bushings - Schmeal (NV) 12:04:07 07/01/16 Yes, ES poly steering rack bushings were done a while ago. (n/m) - MidnightZ 12:26:33 07/01/16 Upper clutch fluid bleed point delete? Have the rack - jzack 12:08:25 07/01/16 Engine pan and rear crank seal done as part of gasket kit. (n/m) - MidnightZ 12:27:39 07/01/16 Also swapped PS return hardline - MidnightZ 12:25:25 07/01/16 Without the trans - -Grimm- 14:36:14 07/01/16
Post a Followup	You cannot reply to this message because you are not logged in.