Subject	A pix of the flare wrench in position.
Posted by	jzack on June 25, 2016 at 11:33 PM
	This message has been viewed 282 times.
In Reply To	Did this job on my 2+2 last summer. My fittings looked to posted by jzack on June 25, 2016 at 09:55 PM
Message	Note- just had the wrench resting to take the picture. It fits nicely above the spot for turning.
Follow Ups	Rear Brake Lines - tcutchall 15:04:48 06/25/16 apply some heat to the nut and use a good flare nut wrench (n/m) - itsa300zx 20:07:41 06/25/16 Re: Rear Brake Lines - Z32_Tree_Killer 20:33:12 06/25/16 Unfortunately I've been using a standard flare nut wrench - tcutchall 23:08:24 06/25/16 Re: Unfortunately I've been using a standard flare nut wrench - Z32_Tree_Killer 23:29:59 06/25/16 Did this job on my 2+2 last summer. My fittings looked to - jzack 21:55:25 06/25/16 A pix of the flare wrench in position. - jzack 23:33:03 06/25/16 Thank you. PB B'laster and that exact wrench worked for me. (n/m) - tcutchall 12:09:40 06/27/16 There ya go!!!! :-) (n/m) - jzack 13:06:47 06/27/16
Post a Followup	You cannot reply to this message because you are not logged in.