Subject	You cannot adjust the clutch properly by making
Posted by	Tanley (ATL) on May 22, 2016 at 2:15 PM
	This message has been viewed 308 times.
In Reply To	Re: Sounds like the pedal was/is adjusted improperly. Did you posted by DTTZ on May 21, 2016 at 10:52 PM
Message	it "engage closer to the floor", that is incorrect. You can only properly adjust the clutch via the guide in the FAQ, when you install an aftermarket clutch. Go and adjust the clutch pedal via the method in the FAQ. You can resurface the flywheel and just replace the disk if need be without replacing the pressure plate, but if you don't properly adjust the clutch or figure out why you can't properly adjust the clutch, you'll burn that disk up too.
Follow Ups	Possible Glazed Clutch, opinions please - DTTZ 16:42:21 05/21/16 Sounds like the pedal was/is adjusted improperly. Did you - Tanley (ATL) 18:45:21 05/21/16 Re: Sounds like the pedal was/is adjusted improperly. Did you - DTTZ 22:52:59 05/21/16 You cannot adjust the clutch properly by making - Tanley (ATL) 14:15:16 05/22/16 Re: You cannot adjust the clutch properly by making - DTTZ 16:54:41 05/22/16 I see, it read like you were adjusting the pedal much closer - Tanley (ATL) 21:20:08 05/22/16 Re: I see, it read like you were adjusting the pedal much closer - DTTZ 23:58:22 05/23/16
Post a Followup	You cannot reply to this message because you are not logged in.