Subject	Re: Sounds like the pedal was/is adjusted improperly. Did you
Posted by	DTTZ on May 21, 2016 at 10:52 PM
	This message has been viewed 296 times.
In Reply To	Sounds like the pedal was/is adjusted improperly. Did you posted by Tanley (ATL) on May 21, 2016 at 06:45 PM
Message	my initial adjustment of the clutch was too far off the floor, ie the clutch wasnt fully engaged all the time which is why i have this problem i believe. So i adjusted it to engage closer to the floor so that when the pedal is fully released it would be ensured the clutch was fully engaged. as of tonight the car wont go into gear, is it possible for the clutch plate to fuse to the flywheel ? And because of the low mileage on the clutch kit would it be possible to just replace the disk and resurface the flywheel without replacing the pressure plate ? Thanks for the response
Follow Ups	Possible Glazed Clutch, opinions please - DTTZ 16:42:21 05/21/16 Sounds like the pedal was/is adjusted improperly. Did you - Tanley (ATL) 18:45:21 05/21/16 Re: Sounds like the pedal was/is adjusted improperly. Did you - DTTZ 22:52:59 05/21/16 You cannot adjust the clutch properly by making - Tanley (ATL) 14:15:16 05/22/16 Re: You cannot adjust the clutch properly by making - DTTZ 16:54:41 05/22/16 I see, it read like you were adjusting the pedal much closer - Tanley (ATL) 21:20:08 05/22/16 Re: I see, it read like you were adjusting the pedal much closer - DTTZ 23:58:22 05/23/16
Post a Followup	You cannot reply to this message because you are not logged in.