Subject	You are right near the bore diameter wear limit >>>
Posted by	ZUL8TR on May 11, 2016 at 3:29 AM
	This message has been viewed 431 times.
In Reply To	Engine block question posted by brandonz on May 10, 2016 at 08:19 AM
Message	of 0.20 mm on the standard bore of 87.00 - 87.03 mm. But there no doubt cylinders are out of round and taper. Agree with white22sky on what to do with a limited budget. But expect a bit low on meeting spec compression numbers and higher oil consumption. [ http://300zx-twinturbo.com/cgi-bin/manual.cgi?list=em&slide=52 ] ZUL8TR in Orlando,FL
Follow Ups	Engine block question - brandonz 08:19:18 05/10/16 I wouldnt bother boring out unless you're - white22sky 11:25:43 05/10/16 Re: I wouldnt bother boring out unless you're - brandonz 12:52:22 05/10/16 Just check your piston/wall clearance - -Grimm- 13:02:45 05/10/16 You are right near the bore diameter wear limit >>> - ZUL8TR 03:29:14 05/11/16
Post a Followup	You cannot reply to this message because you are not logged in.