Subject	Torque spec question
Posted by	frank1991 on May 01, 2016 at 2:06 PM
	This message has been viewed 352 times.
Message	I have been looking for the torque spec on the 2 water inlet pieces that bolt directly to the block. The FSM doesn't show spec for these,just the inlet pipes. Should I use the same specs as the inlet pipes?
Follow Ups	Torque spec question - frank1991 14:06:10 05/01/16 M6 bolts(10mm head)4.6-6.1 ft lbs. - itsa300zx 18:14:23 05/01/16 ^ Agree ^ (n/m) - ttz'in (norcal) 00:41:12 05/02/16
Post a Followup	You cannot reply to this message because you are not logged in.