Subject	I did nothing special just replaced the OEM Connector with a
Posted by	jzack on April 28, 2016 at 2:23 PM
	This message has been viewed 372 times.
In Reply To	Tips on how to repair the shielded wiring on the Det sensor? posted by doug8867 on April 28, 2016 at 12:04 PM
Message	Set of male/female (sealing) crimp on connectors. Put some tape and then heat shrink tubing over the crimp ends where the wire enters the connectors to make sure that side is well sealed too. Never had any issues either. As I recall the actual sensor has no grounding point, the shield just runs to the sensor but doesn't actually ground to the engine block there.
Follow Ups	Tips on how to repair the shielded wiring on the Det sensor? - doug8867 12:04:54 04/28/16 I did nothing special just replaced the OEM Connector with a - jzack 14:23:23 04/28/16 Here are pics of what I am talking about. - doug8867 18:14:58 04/28/16 I forget the specifics - Goldchocobo 21:21:34 04/28/16 yup. (n/m) - Bernie (NoVA) 06:49:56 04/29/16
Post a Followup	You cannot reply to this message because you are not logged in.