Subject	Tips on how to repair the shielded wiring on the Det sensor?
Posted by	doug8867 on April 28, 2016 at 12:04 PM
	This message has been viewed 443 times.
Message	My wiring on the harness that connects to the sub-harness of the Detonation sensor has broken. What is the best way is to repair the shielded wire to prevent electrical noise? I've read things online from wrapping wire in foil to bare stranded wire. I don't have the time or money to spend on replacing the entire engine harness with a new one at this time so looking for the best way to repair this because it's causing a bad ground throughout my system and I suspect it is causing my intermittent codes 34 and code 53 since according to the wiring diagram they both end up tied into the same ground wire back to pin 50 on the ECU. Thanks.
Follow Ups	Tips on how to repair the shielded wiring on the Det sensor? - doug8867 12:04:54 04/28/16 I did nothing special just replaced the OEM Connector with a - jzack 14:23:23 04/28/16 Here are pics of what I am talking about. - doug8867 18:14:58 04/28/16 I forget the specifics - Goldchocobo 21:21:34 04/28/16 yup. (n/m) - Bernie (NoVA) 06:49:56 04/29/16
Post a Followup	You cannot reply to this message because you are not logged in.