Subject	I think I just found my answer:
Posted by	YlwPrlZTT on April 27, 2016 at 8:28 PM
	This message has been viewed 346 times.
In Reply To	Downpipe Spacer posted by YlwPrlZTT on April 27, 2016 at 06:50 PM
Message	The reason you do not want to run the divider on the downpipe is at a certain point it impedes or restricts wastegated exhaust gases and creates boost creep. The wastegated gases cannot exit enough volume of flow that they back up and end up flowing through the turbine wheel. This creates more exhaust gas/energy through to the turbine wheel that is unwanted. The boost starts to climb too high and is essentially not regulated. This happens on VG30s that are moving alot more air due to newer mods like larger intercooler piping, inlet pipes, 3" exhausts, etc. This was posted by someone on TT.net a while ago and the response is from Seb. I guess I'm going to leave the diverter block out.
Follow Ups	Downpipe Spacer - YlwPrlZTT 18:50:22 04/27/16 I think I just found my answer: - YlwPrlZTT 20:28:34 04/27/16 Read that answer by Seb again. - Mongoose 14:57:03 04/28/16 damn it, well, i guess it's back to the storage tomorrow. (n/m) - YlwPrlZTT 18:29:04 04/28/16 Correct. If you had like 530's or 700's with full breather - PiotrC70 10:35:39 04/29/16 In case I can't find them, does anyone know where I can get - YlwPrlZTT 00:13:22 04/29/16 Found them! Thank you all for the help! (n/m) - YlwPrlZTT 16:54:07 04/29/16
Post a Followup	You cannot reply to this message because you are not logged in.