Subject	I think that is backwards..
Posted by	Cjw3 on April 05, 2016 at 2:41 PM
	This message has been viewed 284 times.
In Reply To	Re: Re: no start after Plenum pull. posted by tinner on April 05, 2016 at 11:57 AM
Message	The Fuel comes in from the Filter, and Crosses over to the Right Hand side.. where the Damper is.. Then travels out the Regulator on the Left Hand Side out to the Return line.. Swap them and See. Cj
Follow Ups	no start after Plenum pull. - tinner 10:57:26 04/05/16 Re: no start after Plenum pull. - ttz'in (norcal) 11:49:02 04/05/16 Re: Re: no start after Plenum pull. - tinner 11:57:11 04/05/16 I think that is backwards.. - Cjw3 14:41:22 04/05/16 Re: I think that is backwards.. - tinner 17:11:34 04/05/16 Re: I think that is backwards.. - tinner 17:30:28 04/05/16 Re: no start after Plenum pull. - Metacom 18:18:12 04/05/16 Re: Re: no start after Plenum pull. - tinner 18:24:52 04/05/16 Re: Re: Re: no start after Plenum pull. - Metacom 18:28:48 04/05/16 Criss crossed the fuel in & out hoses. (n/m) - Bernie (NoVA) 18:58:07 04/05/16 Also make sure CAS & PTU connectors are plugged in (n/m) - Bernie (NoVA) 18:59:13 04/05/16 Re: no start after Plenum pull. - tinner 22:13:02 04/05/16 Clean CAS & PTU connectors even if you didn't mess w. them. (n/m) - Bernie (NoVA) 00:34:08 04/06/16 Also did you remove the fuel pump relay before plenum pull? (n/m) - Bernie (NoVA) 00:34:50 04/06/16 Re: Also did you remove the fuel pump relay before plenum pull? - tinner 02:08:15 04/06/16 Did you check the two connectors next to the fuse box? (n/m) - itsa300zx 08:31:05 04/06/16 Re: Did you check the two connectors next to the fuse box? - tinner 15:45:25 04/06/16 Re: Re: Did you check the two connectors next to the fuse box? - Metacom 19:02:48 04/06/16 Balance tube 'O' rings ? (n/m) - ttz'in (norcal) 00:13:46 04/07/16 Re: Balance tube 'O' rings ? - tinner 00:27:55 04/07/16 Re: Re: Balance tube 'O' rings ? - Metacom 01:01:39 04/07/16 What aren't you getting, spark or fuel ?? (n/m) - ttz'in (norcal) 01:16:03 04/07/16 Large vacuum leak would be my guess like Metacom - doug8867 06:38:58 04/08/16 Also make sure the large throttle body hoses are - doug8867 06:40:38 04/08/16 Re: Also make sure the large throttle body hoses are - tinner 10:46:31 04/09/16
Post a Followup	You cannot reply to this message because you are not logged in.