TwinTurbo.NET: Nissan 300ZX forum - no start after Plenum pull.
People Seeking Info
 
   


     
Subject no start after Plenum pull.
     
Posted by tinner on April 05, 2016 at 10:57 AM
  This message has been viewed 344 times.
     
     
Message 91 NA, ran codes before plenum pull, no codes shown up. Car ran fine before the pull. Had a leaking valve cover. Did a water by-pass. Now it won't start. Turns over fine. Have check all grounds and connections. I cleaned the Injectors while the plenum was off. Had that nice green look to them. Unless I missed something will have to start checking spark, fuel and air. Hopping it's something easy.
Thanks

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.