Subject	Need Help with proceedure. I'm dropping my rear suspension
Posted by	ZTicket(Dallas) on April 02, 2016 at 1:54 PM
	This message has been viewed 267 times.
Message	sub-frame to replace it with new part. I have a TT with hydrolic HICAS and the FSM doesn't figure that into the removal proceedure. I'm somewhat intimidated, and don't want a big mess with AT fluid everywhere. What's the best way to do this? Where do I disconnect the HICAS? How many connections(electrical/vaccum) on top of sub-frame need to be undone before I lower the sub-frame from the body? There are two I can see but I'm not sure. I've got a transmission jack to place under the diff, car is on frame dollys, I've got air-tools. Any advice/encouragment would help.
Follow Ups	Need Help with proceedure. I'm dropping my rear suspension - ZTicket(Dallas) 13:54:28 04/02/16 Re: Need Help with proceedure. I'm dropping my rear suspension - Dallas DamonZ 15:27:49 04/02/16 Thanks. If I go HICAS elimination Kit, does it provide for - ZTicket(Dallas) 15:58:34 04/02/16 To turn off hicas light after delete you can disconnect the - Bernie (NoVA) 22:50:42 04/03/16 Thanks Bernie. With that info, I'm leaning more to - ZTicket(Dallas) 07:52:56 04/04/16 Worn rear tie rods need to be replaced no matter what. (n/m) - Bernie (NoVA) 19:00:53 04/05/16
Post a Followup	You cannot reply to this message because you are not logged in.