Subject	Re: Are you using speed bleeders?
Posted by	MaxxAction on March 30, 2016 at 1:31 PM
	This message has been viewed 230 times.
In Reply To	Are you using speed bleeders? (n/m) posted by Tanley (ATL) on March 30, 2016 at 06:40 AM
Message	No... I think the parts store here sells them. I might pick some up. Is it the same thread pattern as the calipers? I have them on the calipers.
Follow Ups	Anyone deleted their clutch booster? - MaxxAction 21:44:45 03/26/16 yes - BarryGZX 22:32:23 03/26/16 Re: yes - MaxxAction 07:30:55 03/27/16 Bore size is the same - BarryGZX 13:27:55 03/27/16 NA master must be used w. NA pedal. (n/m) - Bernie (NoVA) 21:14:23 03/27/16 switched my setup to NA as well...prefer it. (n/m) - Madhatter10-6 10:41:36 03/28/16 Had similar issue. New MC & Slave, bled correctly - ttz'in (norcal) 02:23:30 03/27/16 Re: Had similar issue. New MC & Slave, bled correctly - BarryGZX 07:07:01 03/27/16 Re: Had similar issue. New MC & Slave, bled correctly - MaxxAction 07:32:21 03/27/16 You can check the booster for leaks @ the center piston. (n/m) - Bernie (NoVA) 21:15:08 03/27/16 I'm not sure the problems you are having are related to the - Tanley (ATL) 09:56:05 03/27/16 Re: I'm not sure the problems you are having are related to the - aorqo 11:05:02 03/27/16 I highly doubt it's your booster - Stanky 13:52:39 03/27/16 Re: I highly doubt it's your booster - MaxxAction 17:52:01 03/27/16 Re: I highly doubt it's your booster - MaxxAction 22:04:44 03/29/16 Pull the rubber boot off of the slave. Also inspect the rubb - Bernie (NoVA) 06:30:21 03/30/16 Re: Pull the rubber boot off of the slave. Also inspect the rubb - MaxxAction 13:32:49 03/30/16 Are you using speed bleeders? (n/m) - Tanley (ATL) 06:40:01 03/30/16 Re: Are you using speed bleeders? - MaxxAction 13:31:44 03/30/16 Not suggesting them, just wanted to know if you were using - Tanley (ATL) 18:01:24 03/30/16 Re: Anyone deleted their clutch booster? - MaxxAction 20:14:46 03/30/16
Post a Followup	You cannot reply to this message because you are not logged in.