Subject	Fixed it!
Posted by	Goldchocobo on March 25, 2016 at 7:39 PM
	This message has been viewed 219 times.
In Reply To	The mystery leak posted by Goldchocobo on March 24, 2016 at 04:14 PM
Message	There was a crack in the factory caulking in that small moulding channel right after the T top. I didn't even know they had sealant in there, but apparently they do. I cut out the old sealant, and applied some paintable urethane sealer. I'll smooth it out and have it painted later, but for now I'm happy to have a completely leak free Z!
Follow Ups	The mystery leak - Goldchocobo 16:14:53 03/24/16 So just to be clear...its both coming from above/rear of the - jzack 17:16:27 03/24/16 Correct. - Goldchocobo 19:45:48 03/24/16 Re: The mystery leak - gbhrps 18:42:49 03/24/16 Re: Re: The mystery leak - gbhrps 18:43:41 03/24/16 I'm not the poster but I agree with your diagnosis... - jzack 19:17:49 03/24/16 The tube itself is draining properly, and I don't see any - Goldchocobo 19:50:23 03/24/16 It's possible the tube is draining fine for low water - jzack 19:54:00 03/24/16 I will verify and report back. (n/m) - Goldchocobo 20:02:23 03/24/16 Well, I flooded the t top channels with an overwhelming - Goldchocobo 22:16:50 03/24/16 Is the seal on the 1/4 glass disturbed. Check tube on - Bernie (NoVA) 01:34:35 03/25/16 Thanks Bernie, will do. (n/m) - Goldchocobo 01:41:29 03/25/16 To eliminate drain tube as a possible leak source put a >>> - ZUL8TR 07:00:03 03/25/16 That's precisely what I did, no leak. - Goldchocobo 11:25:59 03/25/16 Fixed it! - Goldchocobo 19:39:30 03/25/16 good for you (n/m) - ZUL8TR 03:10:12 03/26/16 Pix. (n/m) - Bernie (NoVA) 21:23:21 03/27/16 Re: Pix. - Goldchocobo 13:21:55 03/28/16
Post a Followup	You cannot reply to this message because you are not logged in.