Subject	Here is another question. I removed the blend door motor
Posted by	YlwPrlZTT on January 09, 2016 at 8:46 PM
	This message has been viewed 492 times.
In Reply To	The two boxes overlap quite a bit. It takes a fair amount... posted by Ted (92TT) on January 09, 2016 at 04:43 PM
Message	and upon testing I found that it works. I don't want to just attach it back and put everything back together. Can I just plug in the temp control panel, the heater box along with all the other connectors and check if it works? Everything else is disconnected (gauges and all the other pods), I just don't want to short anything out.
Follow Ups	Heater box removal help needed. - YlwPrlZTT 17:26:40 01/08/16 Did you remove the cabin to engine bay firewall gasket that - jzack 17:35:27 01/08/16 no i did not remove that, I noticed it's there but I figured - YlwPrlZTT 18:01:09 01/08/16 It's a good idea to pull the AC BOX lower cover and clean it - jzack 16:56:26 01/09/16 So I got it out. Holy shi*! Next time i'll just buy a new Z - YlwPrlZTT 20:41:39 01/09/16 Yes, the job is a total PITA. Way more time consuming than - jzack 20:48:03 01/11/16 I didn't get all of them off, I left one on and I think - YlwPrlZTT 00:23:17 01/12/16 I also removed the blower completely, it had all sorts of - YlwPrlZTT 20:44:47 01/09/16 Is there any need to remove the a/c box or anything else or - YlwPrlZTT 18:03:02 01/08/16 The two boxes overlap quite a bit. It takes a fair amount... - Ted (92TT) 16:43:02 01/09/16 Here is another question. I removed the blend door motor - YlwPrlZTT 20:46:57 01/09/16 Should be ok (n/m) - Ted (92TT) 13:01:28 01/10/16 Well I tried it but there just seems to be too many things - YlwPrlZTT 16:50:01 01/10/16
Post a Followup	You cannot reply to this message because you are not logged in.