Subject	Heater box removal help needed.
Posted by	YlwPrlZTT on January 08, 2016 at 5:26 PM
	This message has been viewed 829 times.
Message	I finally decided to fix the heat in my Z by replacing the bad air mix door motor. I removed everything according to FAQ as far as the dashboard and a little more. I disconnected the heater core hoses in the engine bay and removed all the nuts holding down the heater box, the a/c box and the blower motor. The heater box is moving around a lot but it does not want to come out. It seems like it's getting held down by either the a/c box or the heater core hoses. Does anyone have any tricks to remove it? I removed the cross member as well to make things easier. I don't want to start pulling too hard and brake the box. Any help is greatly appreciated. Thank you!
Follow Ups	Heater box removal help needed. - YlwPrlZTT 17:26:40 01/08/16 Did you remove the cabin to engine bay firewall gasket that - jzack 17:35:27 01/08/16 no i did not remove that, I noticed it's there but I figured - YlwPrlZTT 18:01:09 01/08/16 It's a good idea to pull the AC BOX lower cover and clean it - jzack 16:56:26 01/09/16 So I got it out. Holy shi*! Next time i'll just buy a new Z - YlwPrlZTT 20:41:39 01/09/16 Yes, the job is a total PITA. Way more time consuming than - jzack 20:48:03 01/11/16 I didn't get all of them off, I left one on and I think - YlwPrlZTT 00:23:17 01/12/16 I also removed the blower completely, it had all sorts of - YlwPrlZTT 20:44:47 01/09/16 Is there any need to remove the a/c box or anything else or - YlwPrlZTT 18:03:02 01/08/16 The two boxes overlap quite a bit. It takes a fair amount... - Ted (92TT) 16:43:02 01/09/16 Here is another question. I removed the blend door motor - YlwPrlZTT 20:46:57 01/09/16 Should be ok (n/m) - Ted (92TT) 13:01:28 01/10/16 Well I tried it but there just seems to be too many things - YlwPrlZTT 16:50:01 01/10/16
Post a Followup	You cannot reply to this message because you are not logged in.