Subject	Here's one I just finished...
Posted by	LitlElvis on January 02, 2016 at 5:33 PM
	This message has been viewed 483 times.
In Reply To	BDE Top Feed upper plenum modification pic request posted by Svt_troy on December 30, 2015 at 10:05 PM
Message	I use a 0.812" spot-face tool and if the core shift is excessive I'll take a flat carbide burr in a die-grinder to remove the hook from the cut (left side of the cut on the upper bolt hole pictured).
Follow Ups	BDE Top Feed upper plenum modification pic request - Svt_troy 22:05:26 12/30/15 Here's one I just finished... - LitlElvis 17:33:50 01/02/16 Re: Here's one I just finished... - Svt_troy 09:00:55 01/03/16 Re: Re: Here's one I just finished... - MagicMike 22:53:10 01/14/16 Re: Re: Re: Here's one I just finished... - MagicMike 23:24:13 01/14/16 Balance tube, anyone??? - MagicMike 19:12:54 01/31/16
Post a Followup	You cannot reply to this message because you are not logged in.