Subject	That wire wrapped around the other is the RF
Posted by	doug8867 on January 01, 2016 at 2:37 PM
	This message has been viewed 431 times.
In Reply To	Re: knock sensor connector posted by spallan on December 31, 2015 at 03:44 PM
Message	shielding/ground wire. It's supposed to look "unraveled" like that. However, near the end of it, it should be clamped to a thin black wire that goes into the connector. If that wire is broken, you can splice it back together with butt connectors, then rewrap it.
Follow Ups	knock sensor connector - spallan 01:38:32 12/31/15 The ECU side of the knock sensor is the short side - doug8867 09:48:22 12/31/15 Re: knock sensor connector - spallan 15:44:53 12/31/15 That wire wrapped around the other is the RF - doug8867 14:37:56 01/01/16 The white wire is the signal wire. - DVDBURN (MD) 15:08:24 01/01/16 Re: knock sensor connector - spallan 18:13:51 01/01/16 I've got a good FAQ out on this. Check it out! (n/m) - OverZealous (CT) 18:26:32 01/04/16
Post a Followup	You cannot reply to this message because you are not logged in.