Subject	The ECU side of the knock sensor is the short side
Posted by	doug8867 on December 31, 2015 at 9:48 AM
	This message has been viewed 391 times.
In Reply To	knock sensor connector posted by spallan on December 31, 2015 at 01:38 AM
Message	on the harness. If you disconnect the connector one side leads out about 6 inches from connector then in goes into the main loom which is about a 1 1/2 bundle of wires. That's the ECU side. The other longer side leads down the back of your engine which is the sensor side.
Follow Ups	knock sensor connector - spallan 01:38:32 12/31/15 The ECU side of the knock sensor is the short side - doug8867 09:48:22 12/31/15 Re: knock sensor connector - spallan 15:44:53 12/31/15 That wire wrapped around the other is the RF - doug8867 14:37:56 01/01/16 The white wire is the signal wire. - DVDBURN (MD) 15:08:24 01/01/16 Re: knock sensor connector - spallan 18:13:51 01/01/16 I've got a good FAQ out on this. Check it out! (n/m) - OverZealous (CT) 18:26:32 01/04/16
Post a Followup	You cannot reply to this message because you are not logged in.